Farmall & IHC Tractors Discussion Board |
Re: Re: Engine on H stopped turning.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by marvin on May 30, 2000 at 13:14:49 from (134.134.248.21):
In Reply to: Re: Engine on H stopped turning. posted by The Red. Hmmmmmmmm on May 30, 2000 at 11:19:25:
The oil pressure was on the upper end of the gauge, which I think was around 35 to 40 pds. We did not check the valve clearance. Although I was thinking about this as a problem as to why the compression was off. When I pulled the head water got into each cyclinder since we did not drain the radiator before pulling things apart. I did see a brown object sittin on top of #4. I vaccuumed the water out and the object sounded like metal going through the vaccuum tube. However there was no marks on the head on #4 to show any obstruction of movement. The piston was also not marked up. I am a little bit concerned about just putting in new gaskets and bolting it back together only to have it happen again and to possibly even damage something else.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|