Posted by caterpillar guy on May 11, 2010 at 03:59:55 from (66.188.53.165):
In Reply to: 886 no stop..... posted by mh on May 10, 2010 at 19:34:38:
It is the throwout bearing. If you take the plate off under the clutch you will find the pieces laying at the bottom. I bet you didn"t know there was a grease fitting for the throwout bearing up in there. We just did all that to our 806 last year. I put a grease line to a bulkhead fitting in the plate so I can grease it from under the tractor without having to remove the plate.
While your in there look at the constant drive spline that goes into the back of the pressure plate if it is worn excessively change it. That runs your PTO and hydraulics. if that has the TA it is real easy to replace that just 3 bolts and pull out. Change the pilot bearing while your in there too. I just cut them out with the torch. Becareful about the heat if you do.I cut the race out then knock the pieces out then cut the other race out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.