The arm on the right doesn't control lift. It tilts the angle of the hitch beam for depth control with the plow.
With the depth control lowered all the way down in front, it raises the rear of the hitch, and consequently whatever's hitched to it. It might be enough to bring the plow out of the ground. Normal transport position on the plow is only about 3" off the ground. Otherwise you wouldn't be able to lower it far enough to plow deep.
On the left side, are you sure you have the correct linkage? These were often abused, bent, ruined, and replaced with homemade pieces. The correct linkage should have some adjustment at the rear end with a nut.
Also, is your touch control working properly? Is it moving through the full range of motion? Does it have adequate power to lift the disk/plow (i.e. it's not stalling out before reaching full travel with the weight of the disk/plow on it)?
If you can determine that your touch control is working properly, then go ahead and do what you need to do to shorten the left linkage and gain yourself a little lift.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.