Posted by ih560 on April 15, 2010 at 13:51:24 from (67.131.50.233):
keith49 sa said: (quoted from post at 04:51:21 03/26/10) hi everyone. i now have the plow all mounted and built a temperary draft arm but i am still haveing trouble geting it to dig in good. i was wondering how long should be? and my draw bar also apears to be bent about 1"-2" down on one side. could this be giveing be a problem? it seems to want to start slideing off to the left when i try to pull it in harder ground instead of diging in. thanks agin guys for the help and pics been a big help.
Here is the factory bar on my Super A. You can see how long it is and exactly how close the drawbar is to the ground, when the front lift is lowered all the way down.
I just plowed with this a month or so ago and it did very well, going into the ground and turning it over. It did take about 3 passes before it was plowing good and deep.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.