Posted by couv on April 15, 2010 at 04:59:32 from (209.33.29.72):
It unfoturnately took several weeks from when I broke down the Touch Control block, until I could put it back to gethr.
I do believe I got all the correct o-rings on the right spool. Cleaned all the gunk out of the bottom of the pan, cleaned the needle-shaped screen.
I was about to put the head on, when I noticed a 5th small spring, ball-point pen sized, coming out of a hole. i believe it came out of the pressure control hole.
I double checked that I had a small spring in each spool hole (on two the springs go in to the front, on two the spools are reversed so the spring is on the head end)
The spring fit inside the metal cap in the pressure control hole, so that's where I put it.
With the tractor running at idle, one lift arm will move all the way to "full up" before the other lift arm moves at all. At full throttle, they move quicker, but still seem to be almost "sequenced" rather than "simutaneous".
Lifting of rear tools doensn't seem as powerful, particularly at less than full throttle.
I did notice that the fresh clean fluid I just installed appears darker than when I put it in just a few months ago. So I put fresh fluid in it again. If I have to take the head off, I'll seee if the fluid is dark again. I checked the filter, it was clean of any gunk. Any idea where the 5th spring goes ?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.