Posted by sflem849 on March 29, 2010 at 18:43:42 from (69.197.84.192):
In Reply to: Farmall H brake Drums posted by famrallh500 on March 28, 2010 at 18:17:28:
famrallh500 said: (quoted from post at 18:17:28 03/28/10) You can removing the seal, but do not remove the 5 bolt plate that is behind the brake drum. The seals can be pulled out and new replacements are 1/2 the old ones. I but two in when I do it, but that is me, some guys just do one seal. just did this last week, and blasted drum, cover and replaced all seals and gaskets in the rear end of an H. Over $250 but there will be no leaks!
Mine cost me $1300 when I did mine... I bought a lot of stuff from Case, but that doesn't explain that big of a difference. That price does include both inner axle bearings and 4/5th gear and some other stuff in there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.