Starting a 706 diesel with 282 is not for the impatient man who cannot follow a specific procedure. You need to hold the glow plugs for a min of 30 seconds, and continue holding them when you start it. Spraying fuel on a glow plug cools them off real fast so just keep them on after it starts for a few seconds depending on temp etc until it is running clear. May be able to let go almost immediately or may have to stay on them a while. Another trick, don't let go of them and then get back on them after it has run long enough for normal voltage of system to build as the glow plugs DO NOT take well to high voltage. I just shut them off and start over, easier on engine and glow plugs. Can't change the design of any particlar engine and system it operates under but you can accomadate it. Oh, lot of blow by, it probably will start hard if it is exessive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
