Posted by pete 23 on March 14, 2010 at 10:26:43 from (173.87.0.197):
In Reply to: MW tenderfoot shifter posted by gene lish on March 13, 2010 at 10:45:03:
I never installed a M&W tenderfoot, however I do adjust one on a regular basis for someone. What they do is lock up both clutch packs,(direct drive and ta lock up ) so as to positively stop the trans shaft and gears from turning so you don't scratch gears when shifting into gear. Trick is, you never fully depress the clutch pedal until gears have slowed down and tractor is not rolling. It is that last little bit of movement of pedal that diverts the oil to both clutch packs. Tricky to adjust and use. I don't know for sure what modifications are made in the mcv as I have never even seen installation instructions. Personally, I don't like them and IH sure did not and it voided all warranty on power train if there was any at time of installation. With that being said, this guy has had it on tractor for at least 20 years and likes it. Did custom round baleing for many years with that tractor so much stopping and starting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
