sflem849 said: (quoted from post at 09:07:33 02/25/10) No luck yet, but I didn't try much. I will be building a puller at lunch.
They had been soaking in JB-80 since Saturday. I really should have cleaned it, but I hate washing in winter w/o a heated shop to go in when you are done.
I am all nervous that I will spend $100+ per hole and still not fix my dilution problem. What the heck, it is only money.
Yeah that open air garage, I feel your pain :lol: Soaking isn't as effective as the pressure washer. Putting the head on saw horse and working it from both sides makes them loosen up pretty well. If you are not pulling the head, then (for the most part) you only need to pull the injectors, not the cups. Those normally come out pretty decent with some twist action to loosen them. None of my engines had ever sat outside with no hood though, so they weren't all that bad to begin with. A bad injector is usually pretty noticeable, and you can observe it yourself before committing to dollars. I know, it's a bad time of year, but a bad one will feel different at the line next to the injector. It will warm slower and the pulses will feel softer. Also loosen the vents and pay attention to the engine. A squirter is easily spotted unless all are equally funky. Late timing can also lead to oil dilution. Is it wet stacking?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.