Posted by Theman on February 25, 2010 at 05:10:14 from (65.198.133.254):
In Reply to: 47 H oil seals posted by jim warehime on February 24, 2010 at 20:13:57:
What worked for me was to use a small 2-jaw puller. It was disassembled to work the jaws in between the shaft and seal then re-assembled to pull on the seal. They came right out. Another method is to use "cutting screws" driven in the side of the old seal in 3 or 4 places. You can pry them out by the screw heads. The problem with this method is that it makes small chips that can end up where you don't want them.
Original seals will have a double thickness - a seal and felt dust shield. The replacements will be considerably thinner and only contain a lip seal. Some folks install just one, yet others put 2 seals with light grease smeared between them. If the new lip seal is not in the groove made by the original, one should be sufficient.
If the above methods fail, follow the procedure given by The Tractor Vet posted a few days back.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.