Dick Binfield said: (quoted from post at 21:40:52 02/08/10) Will 9.50 x 15 tri ribs on 6 bolt 8 in rims fit on an M with factory wide front-- tie rods in the rear? I found a good buy on these tires and rims but need information as to whether they will center up on the spindle/hub.
An M normally would not have six bolt hubs on it but there are some that fit the spindle. If you have six bolt hubs most likely the wheels will bolt unto the hub.
As far as if the wheels and tires would fit you would also need to have the right offset in the rim so that they do not rub. Measure how much clearance you currently have between the tire and spindle and then measure the offset of the rim. Compare that measurement with the wider wheels/tires and see if there is enough room to clear.
Keep in mind that the wider the tire the more the center of the tire contact will move away from the pivot point of the spindle. The farther apart those two contact points are the harder it will steer and the more stress that is placed on the spindle and bearings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
