Hi Neil, I don't have book for D-179 but have book for the 4cyl version D-239. The cyl head bolts are to be tightened in 3 steps, 30 ft-lbs, then 60 ft-lbs, then 90 ft-lbs. There is a bolt tightening squence. Both exhaust and intake valves are set to 0.012 inches. Flywheel retaining cap screws 110 ft-lbs. The main bearings have different settings depending on the type of cap screw all with lubed threads, tighten in 3 steps, 30 ft-lbs, then 60 ft-lbs, then final step as below: Necked down bolts marked: 10.9K set 80 ft-lbs, 12.9K set 100 ft-lbs. Pitch diameter bolts marked: 10.9K set 105 ft-lbs, 12.9K set 141 ft-lbs.
Necked down bolts have a shank diameter of 0.410 inches. Pitch diameter bolts have a shank diameter of 0.500 inches.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.