Brian Peppler said: (quoted from post at 14:32:07 01/28/10) I was looking at the end plate and I think it might
be strong enough for me to remove it and drill and
tap a 3/8 national pipe thread into it and then run
some hydro hoses out and run that to a couple open
center valves.
Yeah, but you can't just drill holes in the end plate.
It's an open center system, which means there can only be one path for the hydraulic fluid through the entire system.
If you drill holes, you create a second path for the fluid to flow. The fluid will always take the path of least resistance, and NONE of your hydraulics will work anymore:
You pull the lever on your spool valve, and the fluid will flow through the 3pt valve. You pull the lever on the 3pt valve, and the fluid will flow through the spool valves.
To work, fluid has to flow out of the pump, through the spool valves, into the 3pt valve, and back into the reservoir.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
