Posted by MNbeekeeper on January 21, 2010 at 10:28:14 from (75.252.253.18):
Good afternoon all. I am seeking advice as to the proper way to size new camshaft bearings after installation. After searching the forums here and recieving "advice" from various sources, I have come to the conclusion that there is a difference of opinion on this. I have done various rebiulds before but this is the first time I have installed single piece bearings. The old bearings were drawn out correctly with a threaded rod and properly sized puck, so no damage to mating surfaces. New Clevite bearings were installed in the same manner. No hammers here! The bearings fit nicely on the new cam which was in tolerance when miced. So, that being said, the bearings after install are to tight. No surprises there. The confusion is how to size them. I have heard to use a brake caliper hone, a bearing scraper, inline boring, to force it in and let it burn clear. The two options I am considering are a hone or inline boring. The hone seems the most economical but was told to avoid this because of contaminants getting into the bearing. Inline boring seems expensive for a simple fix. Bearings are straight and round and I need about .002 off. Any advice on this would be greatly appreciated! Thanks. Art the beekeeper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.