Posted by Harold H on January 17, 2010 at 10:23:55 from (98.18.180.54):
In Reply to: 300 Farmall posted by RDJ Farms on January 17, 2010 at 10:07:21:
The Farmall 300 is the same frame size as derived from the Farmall H. Most have a IPTO but it was optional and some are only equipped for a standard PTO. Live hydraulic were standard but the number of hydraulic valves varies. Two point fast hitch was also optional and now many have been converted to or added three point hitch. As far as mounted implements like cultivators, middle busters, etc, most front mounted implements that fit an H or SH will fit the 300 and the rear section will fit if you don't have two or three point hitch. If you do, you will have to have a two or three point rear section to go with the mounted front section. Also, some front mounted implements will only work with tricycle front whereas some will work with wide or tricycle front. Most likely I would think you will be using three point hitch rear mounted equipment however.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.