More parts to remove before you are ready to slide the head & rotor from the housing.You must remove the advance plungers and the advance ball ( it is screwed into the cam ring),most likely you will need the spline drive tool to remove the ball. There is a 7/16 head screw that is the guide for the governor springs that has to come out ( springs too ) Under the guide screw is the metering valve that is hooked to the governor linkage ( remove metering and the small conical spring under it). Now you should be ready to remove head& rotor ,clamp head lightly in vise and slide housing up off of head ( DO NOT let housing slide down on head or the body O ring will pop out thru a hole in the housing ).
Send me an email and I can send you some pictures of a 560 pump being taken apart.
Allen in ne has my spare tools ,he isn't using them right now .I can get him to send them to you and then you return them to him as he has another pump to do .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
