Posted by CNKS on December 31, 2009 at 18:11:45 from (216.144.104.128):
In Reply to: C aftermarket 3 point posted by valleyview on December 30, 2009 at 18:29:22:
Saginaw makes a 3 point for a C, I have one. Mounting and dismounting is not a problem for me, although sometimes I mount-dismount from the front. The main thing is to get one with its own cylinder, then rigging a remote valve if your C does not have the factory remote. If it operates off the rockshaft, the rod will be in the way and it won't lift as much. As to price on the one you are looking at, maybe 2-$400, a new Saginaw is around $600 + shipping. Yes, fast hitch is better and will bolt up to your C, but finding one in good shape without worn out bushings may be a problem. And unless you are going to use a mounted plow a 3 point should pose no problems.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.