Posted by farmallhal on December 30, 2009 at 19:07:46 from (71.1.111.67):
In Reply to: C aftermarket 3 point posted by valleyview on December 30, 2009 at 18:29:22:
Before putting a 3 point system on your rear entry Farmall C think about how you are going to get on and off your tractor. You may be quite young and agile and don't mind having to crawl over eqipment that is difficult to get around or over to operate your tractor. Three point hitches were designed for side or front entry tractors and not for the letter series Farmalls. Not to say that they won't do the basic mounting and up and down movement they were designed for but I think you are going to lose a lot of the convience you presently have with the proper equipment designed to be compatible with your tractor. I have a Super C with a fast hitch and that hitch is far superior in function and capabilities of any 3 point hitch you are going to be able to put on you C. I don't know what you intend to hook up on your tractor but you might be better off with semi-mount or pull implements for ease of getting on and off your tractor. Just something you should consider and maybe see one with a 3 point implement attached to a C before making a final decision and see what is involved in getting on and off the tractor. I know what I would have to go through in going through a few farm gates in cattle country and crawling over the equipment multiple times in getting into the field I was going to work. Hope your choice works out for you but I would suggest to try and see what you are getting into before parting with the $$'s unless you have already given it a thought, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.