Larry Hardesty said: (quoted from post at 22:33:22 12/28/09) Paul, Thanks, I have the loader manual, It does not show the single cylinder well. However, from your pictures it looks like the base of the hydraulic cylinder rotates on a large pin. Don't know if that hydraulic cylinder is specific to IH or standard stock, but I do not recall seeing one like it in, for example, TSC. I probably will end up redoing the holder of my current single hydraulic cylinder so the top is further forward. Thanks much. A big help
Larry
Hi Larry
I checked my manual, and as far as I can tell, the single bucket cylinder on both the IH 2001 and 1701 loaders are the same, or at least they are both listed as 3 1/2 x 16 inches. My 1701 is currently in pieces, so i will be glad to take photos of the cylinder if that helps. I had my cylinder rebuilt for about $100. Here's an image of one of the two brackets that the cylinder body attaches to.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.