You're missing some parts there on the T/C arm. There are pins with a head to make them look like a flat-head rivet that fit into the larger holes from the face you're looking at in the picture, and hold the rod or whatever else is hooked up there in place.
The head of the pin is held in place by an oblong, rounded diamond-shaped piece of flat steel. The center of this retainer has a small hole in the center, and the tension comes from a pin and spring held in place by a cotter pin (VERY similar to the arrangement on your throttle lever) that pass through teh small hole in the center of the arm. There is then a larger hole at each end of the diamond that is slightly smaller than the head of the pin to be retained.
The idea is that the ppring in the center puts tension on the retainer to hold the poins in place. To release them, you just turn the retainer against the spring tension and turn it sideways to release the heads of the pint.
If you know how to get to the parts lookup on the CaseIH website, look up the Super C, click on hydraulinc system, and then pick p 149. Parts 15 and 16 in the illustration are the small center pin and spring, #20 is the retainer that turns on that pin, and #21 is the larger pin that would hold the arm from the implement in the rockshaft arm.
I don't know where you would find them other than as salvage. You could try Bates or Steel Wheel Ranch. I got some of the large pins from Glen Mlnarik at Little Red Tractor Company. I don't know if he might have the other parts or not, but it would be worth checking.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
