Posted by sflem849 on December 24, 2009 at 07:44:58 from (66.254.196.101):
In Reply to: for HughB posted by Doofus on December 23, 2009 at 05:10:02:
I guess I am the fool in some posts as I only have first hand experience on three machines. I have only ran a straight pipe on an H, SMTA, and GASP>>>MD. (If you remember the original post it said that was where you would really see the problems) I always pull/push (I don't remember) the decompression lever back to diesel when I shut it down to help ensure good valve seating and "proper warping." I also based this assumption off of watching about 15 IH tractors in our pulling club not have any problems with warped valves. This was info was inaccurate in some peoples minds.
I agree, there can be too many "experts" that go off of what they heard on this fourm and most other fourms for that matter. This is one reason I haven't posted my "MD Crankcase Dilution" question for over three years on the forum. (See it below if you have some first hand experience :D ) I probably came off as arrogant, especially in type, by saying don't tell me it's the lift pump bc I changed it. The problem is so many of these "experts" heard somebody had a problem with a lift pump on the only MD in the county so that HAS to be the problem with crankcase dilution EVERY TIME.
So the lower bolster bushing? All three tractors have terrible front ends. I do not have a 360 gear, but I do know of one (and only one) SM with it. When this guy got the tractor he called me and asked why it did that. I said, beats me bc none of mine do it!
BTW, Independence also sucks. Still too many hills!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
