Posted by zooeyhall on December 10, 2009 at 17:39:44 from (74.46.125.189):
I"m thinking about overhauling my Farmall M this winter. The last time it was done was back in 1984. I use it to farm 160 acres so it has had some real hours on it since that time, and it"s starting to use oil.
I know all about replacing the sleeves, pistons, rings, bearings, valves etc. But wanted to know if I should do some other things. This is the third time this tractor will be overhauled, and as I mentioned she is still a working girl and does some heavy crop tillage (mostly tandem disking in the spring and also planting).
For example: should I get the connecting rods and/or crankshaft or block magnifluxed? Should the connecting rod bushings be replaced? This will be the third time the head and block mating surfaces will be smoothed-down. Is there a limit to how many times you can do this? Are there any other things I should do over and above the standard overhaul? Thanks for any advice and it is appreciated!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.