Posted by Matt_In_Michigan on December 01, 2009 at 05:46:49 from (208.53.98.232):
Here"s the short version. Bought new tach cable, hooked it up, snapped off the end. That"s been a while ago. Thought I had a bad cable.
Recently, doing some electrical work discovered the tach seemed set up and wouldn"t spin the needle. Grabbed another 560 tach in my shop, it spun the bearing the cable sits in and the needle. Was it the tach that busted the needle? Could it have been the distributor end?
I"m running 15.5 x 38 rears. How much weight (liquid) should I have in them, and when their filled what sort of pressure should I keep them at?
Lastly, what"s the easiest way to tune the carb? I"ve just tuned "er up, seems to be running much better, but now she"s spitting grayish-black smoke. Considering the oil I found on the old plugs, the smoke"s not a real surprise.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.