I cant say sitting here what solenoid you have so can only describe how a typical Ford type 4 terminal (2 big 2 small) solenoid works.
When in the "START" position a wire down from the IGN switch needs to send 12 votls to the solenoids small (S) Terminal (AND THE SOLENOIDS METAL CASE NEEDS A GOOD FRAME GROUND TO WORK) and the solenoid should engage click and pull in so she cranks.
The Ford Solenoids also have another small terminal labeled I which is hot ONLY WHEN THE SOLENOID IS ENGAGED. It can be used to by pass any ignition balalst resistor for a hotter starting spark in 12 volt tractors that use a 6 volt coil plus external ballast. Its (I terminal) not used if you have a 12 volt coil and dont use any ballast
Soooooooo insure the solenoids metal mount has a good frame ground,,,,,,,,,,,wires its S terminal to the IGN switch so when the switch is in START 12 volts is present
NOTE THIS IS FOR FORD TYPE SOLENOIDS if you have another solenoid let me know
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.