When I was a dealer mechanic, I fixed many out in the field from the back of a service truck. Never had one fail because of dirt, and I'm kind not the neatest person in the world.
Parts are a very close fit so you don't want dirt in there. A super clean area is not necessary however. You need to use a bit of care. I had to fix many when all I had was some gas or diesel fuel, rags, and some compressed air and all went fine.
The most important metal parts fit with such close tolerances that you can't check for wear with a micrometer. You just eyeball them and look for wear patterns. When a part is worn, it's easily seen.
The majority of the time, even failed pumps need very few parts. When I say "failed" I mean an engine that quits and NOT a pump that seizes. With most, a $15 seal kit and new $8 front bushing is all that's needed. For the full deal (what is often called a "rebuild"), you add a new metering valve ($12), fuel pump blades and liner ($18), and maybe a delivery valve ($12). Very rarely do you find anything else that needs replacing.
If a pump has gotten water in it, or perhaps damage from running waste vegetable oil or thin fuel of some sort, the head & rotor assembly can get worn. For that there is no fix other then a new head & rotor. Didn't used to be worth it when Stanadyne charged as much for it as new pump. But now there are aftermarket head & rotor assemblies that cost around $200.
A worn head & rotor results in a seized pump, or an engine that starts well cold but will not start hot. The latter is very common with military Humvees in Irag that get run in high heat and on thin fuel. Humvees use the same basic Stanadyne pump design that your IH uses.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
