That dont sound good because even if you put a genny on the bench n spin it with a motor etc with residual magentism in the iron field poles she ought to put voltage out the ARM post with respect to its frame.
Did you run the Motor Test in the Troubleshooting procedure???? Usually if it passes BOTH those checks it ought to charge. NOTE until the gennys ARM post voltage exceeds that of the battery the VR"s internal cutout relay is open so its not yet even coupled up to the battery so it could charge it.
If you temporarily jump the gennys FLD post to ground does she charge then?? If so but NOT otherwise the VR is bad or the wires bad from FLD on genny to FLD on VR. If she still dont charge when running with the gennys FLD grounded you can by pass jump around the cutout relay n see if she charges then BUTTTTTTTT if the gennys ARM post isnt higher voltage then the battery the relays not gonna close and she still cant charge the battery even if it were BY PASSED JUMPED.
To be safe Id polarize the genny once more then try the ground the FLD test and the motor test but if theres never any voltage at the ARM post shes obviously not working BUT YOU ALREADY KNEW THAT
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.