Posted by pete 23 on November 03, 2009 at 11:06:09 from (173.87.147.73):
In Reply to: farmall 350 hyd posted by robison on November 02, 2009 at 21:15:17:
With out knowing history of problem it makes it difficut to diagnose. Like previous poster said, make sure the single to double action control levers are turned properly. It is very common for them to have a bent or broken roll pin which is the stop. When this happens valve will turn too far and dump oil circuit feeding the orfice in regulator valve assembly. Also, if pin has been bent or broken previously some one may have turned valve far enough to bend the internal link to the point that even when lined up correctly on the outside it still uncovers land inside valve. Saw this happen a few times over the years.Reason that happens is because they rust tight and when they let go, bang, too far. If tractor has power steering , does it work correctly. Has it been removed. Has some one installed flow divider spool backwards. Is regulator valve piston in correctly and or pin broke off or internal spring broken. Lot of different things that have to be ruled out. Most likely, problem is in the changing from double to single action if you assembled regulator valve body correctly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
