Posted by ScottyHOMEy on October 27, 2009 at 12:58:21 from (64.222.222.33):
In Reply to: SA Clutch adjustment posted by Dellbertt on October 27, 2009 at 11:51:32:
There is the normal "Farmall crunch" or grind if you try to shift without waiting long enough for the shaft to stop spinning after disengaging the clutch, that's just the nature of the beaset. But if you can't get it into gear after five seconds of holding the pedal down, then, yes, you have something going on.
If the clutch releases enough to let you stop and shift it should also release after being engaged in neutral. I don't think your problem is the clutch but it wouldn't hurt to check your freeplay. By way of verifying, once the freeplay is set according to pedal travel, you should be able to peek in thorugh the hole in the left side of the bell and see about 1/4" between the face of the throwout bearing and the clutch fingers.
I'm more suspicious of your pilot bushing.
On the times you stop the tractor with the clutch engaged and can then shift, if you stopped with the transmission still engaged in a gear, that would stop the shaft as well, enabling you to shift to another gear. In that case the pilot bushing would be spinning around the end of the shaft as it should.
If you let it run in neutral with the clutch engaged, the shaft gets spinning at the same rate as the pilot bushing. If the pilot bushing is sticky from being dirty, there is enough angular momentum on the input gears at the back end of the shaft that the extra input from the sticky bushing could be enough to keep them turning. That could be the case even if the sticky bushing isn't enough to start the shaft up on it's own, either starting up up with the clutched released and the gearbox in neutral at the beginning of the day, or after releasing the clutch and stopping with the gears still engaged,which would be consistent with what you're experiencing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
