Posted by Tom Fleming on October 16, 2009 at 02:38:06 from (206.193.247.91):
In Reply to: Just a Ring job? posted by TedD17 on October 14, 2009 at 18:39:59:
I agree with most of what has been posted so far. I would take the plugs out, and put some of your favorite "snake oil" into each cylinder (ie. blaster, Kroil, marvel mystery oil, ATF, kerosense, diesel, and on, and on) and let it sit for 1-2 days. Crank it over a bit after the 2 days, and then put the plugs in. Fire it up, and run it getting it up to temp, and keep running it. I think you will find that the rings free up, and you may not have as much "wrong" as you think you do.
Key here is to get it up to temp, and then work it if you can. Rings can stick on engines that sit that are not stuck.
As always IMHO.
This post was edited by Tom Fleming at 02:43:12 10/16/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.