Posted by Chuck's Repair on October 11, 2009 at 14:11:17 from (162.40.106.144):
In Reply to: 856d valve setting posted by docjoe on October 10, 2009 at 15:40:01:
Start with #1 cylinder TDC compression stroke(both push rods will be loose).Adjust valves on that cylinder. Rotate flywheel in the direction of rotation until #5 cylinder is at TDC. (You have to watch the valve movement on companion cylinders to know when you are at TDC. Companoin cylinders are 1&6 2&5 & 3&4. So when #2 exhaust valve just closes and the intake valve just starts to open and both push rods are tight #2 cylinder is at TDC exhaust stroke and you can adjust the valves on #5 which will be on TDC compression stroke.) Adjust valves on #5 cylinder and continue to rotate the flywheel in the direction of rotation 1/3 of a turn to adjust the next cylinder in the firing order. Firing order is 1-5-3-6-2-4. You will be able to adjust all 6 cylinders in two revolutions of the flywheel. Chuck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.