Posted by Tom in Iowa City on October 10, 2009 at 15:52:59 from (173.21.35.134):
Just brought the family 15-30 (22-36) back from the family farm in Idaho, to Iowa City. In only one week’s time, I have removed the cylinder head (140 pounds), the platform and “fenders” and a bunch of other stuff…all for cleanup and assessment. Hasn’t run for decades. I was able to pull the left rear wheel without difficulty with my wheel puller. HOWEVER, the right rear will not pull. Here’s what I have done to try: numerous applications of penetrating oil, numerous heavy raps on the wheel on many parts of the wheel. Attempted to use the wheel puller, breaking many of the bolts that fasten it together. Purchased some hard (number 9) bolts and began to pull without luck. Many more hard raps. Then, put a long galvanized pipe on the ¾ inch drive ratchet. I am afraid I may break the puller if I turn REAL hard…might be advisable to use the breaker bar. The penetrating oil cannot get all along the splines, probably. Would welcome any suggestions. Thought about getting a large piece of bar steel and getting a sledge hammer to rap from the left to the right (in the direction of removal from the splines). Don’t know how much force to use. Thanks, Tom
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
