Posted by scot in pa on October 08, 2009 at 14:14:19 from (12.171.163.30):
In Reply to: Re: Disc on Super M posted by soybeanjoe on October 04, 2009 at 10:18:36:
I'll agree there. We had a 22' IH disk that I pulled one year with the 1566, in hi-1 usually, and the stops set to where the wheels were just carrying a little weight. Did a great job
The next year I wasn't there, they put it behind the Steiger and lifted the wheels off the ground. With all the slop in the drawbar and the oversize hole in it, there was so much slop the LF corner would dig in, and the tongue would swing over that way, then the right would do the same thing. Talk about rough ground.
Sod I usually double-lapped in hi-1 or low-4 (usually disked with a 10), and on chiseled ground or moldboarded corn ground hi-1 or hi-2.
And I always disked at least 60 feet across the end. That was over 6 widths of the haybine, or later, 4 widths of the discbine. I couldn't get my one cousin to disk the ends past the headland and woulda like ta kick his teeth in when it came time to make hay.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.