I agree with the others--- a 140 should handle a 72" woods mower with no problem. For over 10 years my brother and I mowed the township cemetaries and 2 churchyards (3-plus acres each) with a Farmall A with a U? 306 mower mounted on it. The mower mounting was all homemade and blackmith rough, but it worked great! Whoever mounted the mower on it used the big cast pulley that mounted on the regular 540 PTO shaft and the thing mowed like a gang mower--- very even. I always suspected that it was due to the blades turning faster due to that huge pulley. One thing you had to watch in close quarters when pushing in the clutch was its tendency to move you into a fence or other obstruction if you didn't bump the transmission into neutral--- I hate to argue with Rusty, but this particular animal could've used an overrunning clutch. We still use the thing now some 30 years later. I'll post some pics of it after our tractor show is over tomorrow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
