Posted by Wardner on September 24, 2009 at 17:22:50 from (4.154.247.63):
My hedge is 7' high and 7' wide. I had this IH balanced head mower on my 4000# forklift. Because it rained every other day in June and July, I wasn't able to use it. Plus I couldn't see the top of the hedge. Now I can if I flip the seat and stand up for good visibility.
The sickle bar will cut vertical and horizontal. It is rotated into position with electric/hydraulic power pack controlled from the operator's position.
The Borg-Warner clutch pump runs the knife. I can turn it on and off from a switch near the left headlight. I also have a switch for the lift.
I can even mow at night. It runs off the Electrall. I have been thinking about getting an antenna rotater.
I now have 15 V-belts installed on the tractor.
Somebody stop me before I mount the air end, oil cooler, and oil separator from my first air compressor. It's a Sullair 150 CFM. Takes about 45 hp. It's that or a welder (or maybe both).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
