Posted by ScottyHOMEy on September 22, 2009 at 09:54:37 from (71.241.217.40):
In Reply to: Farmall H flip up seat? posted by ryanwheelock on September 22, 2009 at 09:34:36:
Flip-up seats on Cs, Hs and Ms were an option. The basic seat was simply a seat of the standard four-bolt pattern affixed to the seat mount.
There were two designs. The optional flip-up seat for the C/SuperC was a three-piece mount that bolted to the seat mount and to the underside of the standar four-bolt seat. I don't knwo if this was offered for the H or M, but it's design might have hade it possible, and I have a vague but unreliable recollection that the flip-up on Grandpa's 400 was of this type.
The other type used a different seat pan than the four-bolt. It had two parallel rails on the underside. Each rail had a hole near the upper/rear end to accommodate a hinge pin, and an arcguide for another pin to allow the tip-up motion. Bates Corp has a good picture of the underside of this type which might be more helpful than my attempt to describe it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.