Wardner I know what you mean. When you keep spare parts, rarely are they needed... But if it has a 5 week lead-time and you have 40 acres of hay on the ground with a threatening hurricane it will fail. I knew the clutch had some age on it and I had adjusted it some before. I also have used the loader ALOT moving dirt and that is hard on a clutch.
By the way, the camera is my 2nd Casio EXLIM 10.1 MP. I ran over the first one with the tractor and root rake, but salvaged the battery and memory card. It has 3x optical zoom, more digital zoom than you'll ever need and shoots excellent video. It will shoot pics at low light without a flash that looks like daytime and fits in your shirt pocket. Got this one off EBAY refurb for $115, it is over $300 retail.
When I inspected the first time it was raining and I was looking through a 4"x8" hole. I did not see the pin the first go round. But as I was waiting on parts and talking to people, it did not make sense. That is when I started bumping the flywheel around and looking HARD for a sign.
I am going to try to mow some today and try it out. It is VERY wet out, but I need to disk the land anyway. Other than TractorManNC, has anyone else had a similar issue with the clevis pin "walking" out? Where did the cotter pin go?
Any advice for adjusting the release finger stud and jamb nut while on tractor? Or should I just do it and call it good. One finger is dragging the throw out and it seems that it has been doing it for a while. The face of the bearing has wear and it is a little sloppy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.