1.188 Inches. The pressure plate and clutch disk fit on different shafts because of the live PTO. Pressure plate bolts to the flywheel, and the hollow PTO shaft fits into it. Clutch plate fits on the solid shaft that goes thru the PTO shaft and goes into the pilot bearing. If you bolt the pressure plate to the flywheel before putting the front and rear back together, you run the risk of not having the clutch disk aligned properly (the main shaft flops up and down until it slides into the pilot bearing) and it can and will bend. Been there and bent it due to not knowing any better, ie stupidity. As stated you can use a GOOD alignment tool if you insist on bolting it first. I am not familiar with your engine. You have to drop the oil pan to change the main bearing, I don't know what else. Splitting the tractor is independent of changing the main bearing, you can change the rear seal then, I suppose. Changing the front trans seal (actually it is the TA seal) is up to you. You can see if it leaks once you split the tractor. Mine was not -- that is not to say it won't.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
