Posted by tbraley on August 21, 2009 at 06:09:27 from (67.142.164.24):
I have a manual that tells you how to bleed the system, it says:
"To bleed the system, fill reservoir to the bottom of filler hole then start engine and cycle system until any air is bled from system. Recheck reservoir fluid level and add fluid as required"
Now I am NEW to this so this may be a stupid questions. I had to change a hose for the back hoe and now it works very slow and is very week.
It says to fill to the bottom of filler hole, Where is the "bottom of filler hole"?
Do I take the filter out to see this?
I filled the Hydraulic tank up and started the engine. I had left the cap off and nothing would work. When I screwed the cap to the Hydraulic tank back on the hoe would work but was slow and weak.
Now I had to unscrew 3 lines that go under the hoe seat to change the new line. So I assume air is in the lines.
The direction really don't make any since to me. Can any help me on bleeding the system?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.