Posted by Hugh MacKay on August 17, 2009 at 02:54:12 from (216.208.58.101):
In Reply to: Pto posted by adrian on August 16, 2009 at 17:03:05:
Adrain: Yes it can be rebuilt. I have no idea on cost, haven't had one done for 30 years.
Removal is quite simple, find a spot where front wheels of tractor are about 18" lower than rear wheels. With front wheels lower you don't have to drain transmission. 4 bolts to take out to remove PTO unit. Inside you'll find a short shaft and two couplers, remove those if you intend to use tractor while PTO is being rebuilt. Nothing holds those in place, exept PTO.
If you want to use tractor while PTO is being done, cut a piece of 3/4" plywood to cover hole at back of tractor. Drill holes to match holes that hold PTO. Then use short bolts to bolt plywood on. I used big washers on those bolts. One cover fits all, from 300 to 560. I've run tractors steady for a week with the plywood cover. Keeps dirt and dust out of transmission even if tractor is parked.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.