I sure do appreciate the good information on pulling the Cub crank pulley. I worked for about five years at the local IH dealership here in Talladega and after having my memory jogged I think that the tool we had there was similar but used a big threaded rod to pull the pulley and took a long time and a lot of sweat.
I'll fabricate something similar to what you guys have done and see how I come out.
This is a block I'm trying to bore because it is badly worn in the bore and the crank is broken behind the #1 journal. Also the other two main caps are missing. Really just trying to hone my skills at operating the boring bar that the micrometer is not calibrated right on. Having to do some math to get the bore to come out right!!!!
Anybody want to let me have some old main caps so I can get it line bored. The block will be .030 bore when I get it done. (unless I read the mic wrong!) It's a really old Van Norman Model 944 bar where the cutting tool holder has to be set in a mic holder to set the cutting size and it gets tricky when the mic reads .020 over the actual size it cuts. That has to be factored in before the bar is started cutting. My old brain is having a hard time with the calcuations. My old brain is having a hard time finding my false teeth some days!!!! :O)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
