Posted by Toddar on July 29, 2009 at 17:32:48 from (67.54.176.38):
Just bought a IH 47 twine baler. Owner said he used it last year, there was straw still in it. He had the older rope looking twine in it,so I bought some poly twine 9000/130 from rural king.
I threaded it through the baler. As I was pulling it through the needles I noticed the twine pulled pretty hard. I checked all of the eyelets for a ware groove and they were all fine.
I ran some straw through it and noticed that it was not cutting the twine. Made an adjustment and the next bale it cut.
Now the PROBLEM, it would not tie the bales so I was watching the knotters and noticed that when it did knot, everytime the plunger came forward to pack the bale the knots would slip off of the knotter,it would take about three cycles of the plunger for this to happen.
Is my problem some cheap twine. Should I get some from a dealer. Thanks for any advice. Todd
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.