Posted by CoopertownBob on July 18, 2009 at 15:11:48 from (74.51.5.11):
In Reply to: Farmall M puller posted by cory smith on July 17, 2009 at 18:46:32:
First, insure you are not having a fuel feed problem by bypassing your fuel line setup and using a line run from a plastic bottle to the carb. Just cut a hole in the side of the bottle almost at the bottom and silicon some fuel line into it. Hook other end to carb fuel inlet and be sure to hold the bottle higher than the carb. If it runs fine like this, you need to change the route of your fuel line or maybe it or your filter is clogged, or maybe they are just not big enough to handle the fuel requirements. If it still has the trouble running that way, then you have eliminated fuel flow issues. Time to try something else.
Try setting your initial timing at idle to dead 0, then leave the lock down bolt loose while you try adding throttle. Twist distributor to move timing up or down till it smooths out. If you find it will run just fine when advanced or retarded severely, then you have the distributor in one tooth off. Either pull and reinstall distributor correctly, or just move each plug wire up to the next hole and don't worry about it. The only other thing is it could have too much advance built into the distributor. You'll need to ask the person who rebuilt it for you how much they put in, or if they say they left it stock, then it is 40 degrees worth of advance.
If neither of the above work, let me know and I'll give you some more suggestions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
