Posted by ScottyHOMEy on June 24, 2009 at 08:29:32 from (71.241.192.106):
In Reply to: Re: Super C fan hub posted by Idaho Ron on June 23, 2009 at 19:33:22:
I'm sharing Hugh' suspicions, Ron.
It's not sure-fire, but one possible way to verify that it has a sealed bearing kit in it is to look at the front of the fan shaft.
I say not sure-fire because different kits may have used bearings of different dimensions, but the kit I got from Mark's Tractors a few years back did not allow me to replace what had been the front cover for the front end of the shaft. Its the round plate with the bump in the middle that was attached with four screws and would remind you vaguely of the cone on the front of an airplane propeller. If that's not there, you can pretty much figure that it has sealed bearings in it, as the oil would all have leaked out of the original set-up. If it is there, it may still be a toss-up, but as Hugh suggests, the absence of the filler neck is a pretty good clue that it has sealed bearings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.