Posted by SUPER TRUCKER on June 09, 2009 at 17:01:39 from (99.36.9.56):
HEY GUY'S JUST HAD MY FIRST DEAD WEIGHT PULL WITH MY M. WHAT FUN I HAD ! 5500 WEIGHT ON THE BACK AND PRESS WHEELS IN THE FRONT = TIRES ABOUT 3.5 ft OFF THE GROUND. 2ND PULL 125lbs ON FRONT PRETTY GOOD. THE QUESTION I HAVE IS HOW MUCH CAN I MILL THE STOCK HEAD[ I'M PREETY SURE IT NEEDS FRESHENED UP]. MOTOR DYNO'S 45 HP AT 540. AND IS THERE ANY OTHER NEAT TRICKS OUT THERE THAT ARE RELIABLE? I STILL PLAN TO DO PLOW DAY'S. ANY HELP WOULD BE GREAT.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.