NO, I dont think thats the problem. It should still charge regardless if loads are fed from LOAD on a 4 terminal VR or the Load side (same side that wires to BAT on the VR) of an ammeter. The ammeters SUPPLY terminal has the wire to the battery/starter while its other LOAD terminal wires to BAT on the VR PLUS feeds loads like lights and ignition, unless its a 4 terminal VR in which case loads are fed from the VR's L terminal.....If I had a 4 terminal VR with the LOAD terminal I would feed lights n ignition off it versus the ammeter, but it will still work if you ignore the L terminal.
On many 4 terminal VR's the 3 terminals side by side are BAT LOAD FLD while the one on one side or the bottom by itself is the ARM/GEN terminal GOT IT WIRED CORRECT???
Run the Para 5 VR by pass tests and the Para 8 motor tests may help diagnose the problem
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.