Posted by Hugh MacKay on June 04, 2009 at 02:16:13 from (216.208.58.98):
In Reply to: 686 Power and Tires posted by Stigmont on June 03, 2009 at 15:45:09:
Stigmont: I went from 15.5x38 to 16.9x38 on my 656 and 560, did it mainly to give better rear end clearence. At the time I also went from chloride filled 15.5x 38 to no chloride in the 16.9x38. Yes it did make a huge difference. With 15.5 on the 656 I never gave a thought to hooking up to 5x16 semi-mount plow. After the change to 16.9, all I ever plowed with was 656.
I don't think you want chloride in there, 16.9 and 18.4 hold a lot of chloride. It will rob the 686 of too much power. I noticed this in my change from 15.5 to 16.9, tractors were much more lively and resopnsive, didn't leave near as many wheel tracks in soft ground. I noticed the same going from single, chloride filled, 20.8x38, to dual, air only, 20.8x38 on 1066. I takes hard ground to take advantage of all that added weight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.