Posted by Hugh MacKay on May 19, 2009 at 19:31:29 from (209.226.106.83):
In Reply to: Re: Plowing with a H? posted by rustyfarmall on May 19, 2009 at 08:45:32:
Rusty: Pulling a trailer plow is much like pulling a stone boat. When the average IH trailer plow is plowing 8" deep, the pivot point of plow and tongue is roughly 6" off the ground. The hitch end of tongue at tractor drawbar is roughly 15" off the ground. Now, most folks will agree that a 3.5' tongue at that sharp angle will exert considerable down draft on tractor wheels. The further that hitch point is from tractor rear axle, the more down pressure the draft will exert on tractor rear wheels. Believe me, this is how Harry Ferguson and others learned that if you extend that hitch point back even further than the swinging drawbar, it becomes very easy to transfer plow weight and soil to moldboard suction to rear wheels of tractor. Well my friend, good trailer plows also transfer a lot of weight if that swinging drawbar is long enough. Having said that, I doubt if one could keep the front wheels down if the swinging drawbar were rigid enough and extended 4' beyond the U drawbar, you couldn't steer it, but man would it pull.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
