Posted by LMack on April 28, 2009 at 18:17:10 from (98.66.226.167):
In Reply to: super c trans fluid posted by bg/mo on April 28, 2009 at 09:34:24:
The seal against the tractor is a gasket, CIH did not carry it when I tried to buy one so I made one from blank stock. If there are shims they will probably be needed to keep the gear mesh right. I put gasket seal between each of the shims as I put it back together. The seal at the end of the belt drive depends on centrifugal force to seal rather than a pressure seal. There is no grease seal between the spacer and the shaft. The oil seal does little with the grease spun to the outside walls of the housing. I have been told that the shims between the bearing housing and the body of the belt pulley will not leak, but I still put silicone between every shim. If you do not have a pulley on the belt pulley shaft you must use a blank cover to hold the spacer in. Without it nothing except friction holds the spacer in place. The blank covers are hard to get and I have made them from 1 1/4" round fence post. Use a pipe cutter and cut it to 2 1/16". Spacers are avaliable from CIH. Do not overfill with oil as there is no oil seal against the belt pulley shaft and oil will leak out if you fill above the level of the shaft.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
