You do not have a 1954 Super M. You might have a 1952 or early 1953.
First off make sure that you do NOT have hoses running to a unit located in front of the distributor. What I am about to explain assumes that you do NOT have this live pump. If you do have a live pump, then DO NOT FOLLOW any instructions I list below. Read it for educational purposes only. You will blow something up if you follow my instructions with a live pump installed.
What you have is officially known as the transmission-driven Liftall system. We call it a "belly pump" for obvious reasons.
It's a self-contained system that is driven off the transmission of the tractor. You need to have your foot off the clutch pedal to get pressure. It is not live hydraulics.
There is a fill pipe under the gas tank on the right hand side, in front of the belt pulley on top. Usually there is a dipstick in there, but sometimes they get lost. Sometimes the owner will connect the return from a two-way valve to this pipe.
On the sides, there should be two holes on the left and one on the right (maybe vice versa, I'm working from memory and my head is foggy this morning from lack of sleep). These are all pressure OUT ports. The front port on the left and the single port on the right put pressure out at the same time. The rear port on the left has a short delay.
The lever on the right side is the control for the hydraulics. It should be connected to a rod that goes up to the operator's platform. Pull the rod back for pressure, let it slide to the center for neutral/hold, and push forward slightly to lower.
Your tractor has hoses, so it is likely that someone added a two-way valve. In order for the two way valve to work you need to lock or tie back the control lever on the side of the tractor, then operate the two way valve.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
