Posted by El Toro on April 18, 2009 at 14:06:49 from (64.12.116.73):
In Reply to: 300 wont fire posted by makin'hay on April 18, 2009 at 12:28:00:
You need to pull No1 plug near the radiator and bring No1 piston to TDC on the compression stroke. Then remove the distrubutor cap and see where your rotor is pointing. It should be at the No1 plug tower. If it isn't you need to pull the distributor and turn the rotor to the No1 plug tower and reinstall it.
If it points to No1 you need to check your plug wires to make sure they're in the correct firing order on the distributor cap and to the correct sparkplug. Your rotor probably turns CW and your plug wires should be in this order on the cap.
2-1 4-3
While your engine is at TDC check to make sure the No1 plug wire is connected to No1 sparkplug. Then the next plug wire to No3, then No4 and No2. You may have the plug wires crossed causing it to backfire. Hal
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.